Why this Blog?

The purpose of creation of this new blog was to add all my work that will solely related to my DIY Solar and wind electricity generation system. I will also add here the adventure of my DIY micro-hydro turbine (PAT) unit that has been planned to be implemented in the beautiful Kalam valley. In the recent past i unintentionally got attraction toward the green energy and studied a lot about.

My last visit to Karachi home was the turning point to divert all my intentions and resources toward getting into hybrid solar+wind electricity system. The 12 hours shedding at Karachi was really a mental shock to me. The 2Hours alternate load shedding scheme was so pathetic that for three nights i had only 6 hours of sleep in total. The Starting/Stopping the generator (located at the third floor) was a real muscular exercise especially the last part of the night.

The ready made solution requires a handsome amount of money. Here i will post my DIY approach to get the job done considering the advantage of being low cost, worth of experience and as per my requirement and quality. I intend to work on both Solar and wind turbine simultaneously so that to give the relief to my family.

Lets see will i have success in this endeavor?



Saturday, September 1, 2012

Wind-Solar Hybrid Charge Controller on its way

Today i purchased the Wind Solar hybrid charge controller with following parameters:


Rated Battery Voltage
24V
Rated Wind Turbine Power
600W
Wind Turbine Maximum Input Current
40A
Wind Turbine Maximum Input Power
1000W
Unload Voltage(factory default)
28V
Unload Current(factory default)
25A
Rated Solar Power
300W
Battery Over Discharge Voltage Shutoff
22V
Battery Over Discharge Recovery
24V
Output Protection Voltage
32V
Display Mode
LCD
Display Parameters
Wind Turbine Power, Wind Turbine Voltage, Wind Turbine Current, PV Voltage, PV Charge Current, PV Power, Battery Voltage,
Over Voltage, Under Voltage, Over Load, Short Circuit, Night. Etc

No comments:

Post a Comment